Billion Electric Company BiGuard 10 User Manual
15
Port
Meaning
1 RESET
After the device is powered on, press it to reset the device or restore to
factory default settings.
0-3 seconds: The Status LED will light
6 seconds above: restore to factory default settings (this is used when
you cannot login to the router. E.g. forgot the password)
factory default settings.
0-3 seconds: The Status LED will light
6 seconds above: restore to factory default settings (this is used when
you cannot login to the router. E.g. forgot the password)
2
LAN
1X — 8X
(RJ-45 connector)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the eight LAN
ports when connecting to a PC or an office/home network of 10Mbps or
100Mbps.
ports when connecting to a PC or an office/home network of 10Mbps or
100Mbps.
3
WAN
WAN 10/100M Ethernet port (with auto crossover support); connect
xDSL/Cable modem here.
xDSL/Cable modem here.
4
DC12V
Connect DC power adapter here.(DC12V Power)
1.3.2.3 Cabling
Most Ethernet networks currently use unshielded twisted pair (UTP) cabling. The
UTP cable contains eight conductors, arranged in four twisted pairs, and terminated
with an RJ45 type connector.
One of the most common causes of networking problems is bad cabling. Make sure
that all connected devices are turned on. On the front panel of BiGuard 2, verify that
the LAN link and WAN line LEDs are lit. If they are not, check to see that you are
using the proper cabling.
UTP cable contains eight conductors, arranged in four twisted pairs, and terminated
with an RJ45 type connector.
One of the most common causes of networking problems is bad cabling. Make sure
that all connected devices are turned on. On the front panel of BiGuard 2, verify that
the LAN link and WAN line LEDs are lit. If they are not, check to see that you are
using the proper cabling.