Barco DCS-200 User Manual
26
DCS-200 • User’s Guide
2. Hardware Orientation
DCS-200 Rear Panel
3) HD/SD SDI Input
One BNC connector is provided for the SD-SDI or HD-SDI input.
4) Main
Outputs
Two connectors are provided for the DCS-200’s main program outputs. Both
outputs have the same resolution, and both can be used simultaneously.
outputs have the same resolution, and both can be used simultaneously.
~
One DVI-I connector is provided for the system’s digital program output.
There are no analog outputs on this connector. In Appendix A, refer to
the “
There are no analog outputs on this connector. In Appendix A, refer to
the “
” section on page 119 for pinouts.
~
” section on
page 118 for pinouts
5) Serial
One DB-9 connector is provided for Serial communications with the DCS-200
system. The port is also used for diagnostics or command-line operations.
system. The port is also used for diagnostics or command-line operations.
6) Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the DCS-200 system. The port is used for running the built-in web-based GUI, for
diagnostics, or for command-line operations via Telnet (using port 23).
the DCS-200 system. The port is used for running the built-in web-based GUI, for
diagnostics, or for command-line operations via Telnet (using port 23).
S
telnet 192.168.0.10 23
In Appendix A, refer to the “
” section on page 120 for
pinouts.
7) AC
Power
One AC Connector is provided for connecting DCS-200 to AC. The integral
switch turns the chassis on and off. In Appendix A, refer to the “
switch turns the chassis on and off. In Appendix A, refer to the “
8) Preview
Outputs
Two outputs are provided for connecting to the Preview monitor: an HD-15
connector for analog monitors and a DVI connector for digital displays.
connector for analog monitors and a DVI connector for digital displays.
Note
The DVI-I connector allows you to use both DVI-D and DVI-I
cables as required.
cables as required.