ZyXEL Communications GS-1548 User Manual

Chapter 8 VLAN

GS-1524/GS-1548 User’s Guide

Use a IEEE 802.1Q VLAN to decide whether an incoming frame on a port should be

• sent to a VLAN group as normal depending on its VLAN tag. 
• sent to a group whether it has a VLAN tag or not. 

You can also tag all outgoing frames (that were previously untagged) from a port with the 
specified VID. 

Use this screen to display IEEE 802.1Q VLAN status. Click VLAN in the navigation panel to 
display the IEEE 802.1Q VLAN screen as shown next.  

Figure 33   VLAN: VLAN Status  

The following table describes the labels in this screen.

Table 12   VLAN: VLAN Status 

VLAN ID

Select which VLAN you want to configure or click Create New VLAN to go to the 

new VLAN configuration screen.

VLAN Status 

Table

This table shows you the existing VLANs and their configurations.

VLAN ID

Click on the VLAN ID to go to the VLAN edit screen.

Member Ports

All the ports participating in the VLAN are listed here. The ports show up in two 

different colors:

•  (Orange) When the packet leaves this member port, the VLAN tag is 

added. 
•  (Turquoise) When the packet leaves this member port, the VLAN tag is 

removed. 

Previous Page

Click this button to view VLANs with lower identification numbers. This field is only 

active if there are more VLANs than can be displayed on one screen.

Next Page

Click this button to view VLANs with higher identification numbers. This field is only 

active if there are more VLANs than can be displayed on one screen.