ZyXEL Communications 4728F User Manual

Chapter 20 Classifier

XGS-4526/4528F/4728F User’s Guide

To view a summary of the classifier configuration, scroll down to the summary 
table at the bottom of the Classifier screen. To change the settings of a rule, click 
a number in the Index field.

Note: When two rules conflict with each other, a higher layer rule has priority over a 

lower layer rule.

Figure 88   Advanced Application > Classifier: Summary Table 

The following table describes the labels in this screen.  

Socket 
Number

Note: You must select either UDP or TCP in the IP Protocol field before 

you configure the socket numbers.

Select Any to apply the rule to all TCP/UDP protocol port numbers or select 
the second option and enter a TCP/UDP protocol port number.

Add

Click Add to insert the entry in the summary table below and save your 
changes to the Switch’s run-time memory. The Switch loses these changes if it 
is turned off or loses power, so use the Save link on the top navigation panel 
to save your changes to the non-volatile memory when you are done 
configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Clear

Click Clear to set the above fields back to the factory defaults.

Table 49   Advanced Application > Classifier  (continued)

Table 50   Classifier: Summary Table 

Index

This field displays the index number of the rule. Click an index number to edit 
the rule. 

Active

This field displays Yes when the rule is activated and No when it is 
deactivated.

Name

This field displays the descriptive name for this rule. This is for identification 
purposes only.

Rule

This field displays a summary of the classifier rule’s settings.