ZyXEL Communications 4728F User Manual
Chapter 23 VLAN Stacking
XGS-4526/4528F/4728F User’s Guide
224
Click Port-based QinQ in the Advanced Application > VLAN Stacking screen
to display the screen as shown.
to display the screen as shown.
Figure 96 Advanced Application > VLAN Stacking > Port-based QinQ
The following table describes the labels in this screen.
23.4.2 Selective Q-in-Q
Selective Q-in-Q is VLAN-based. It allows the Switch to add different outer VLAN
tags to the incoming frames received on one port according to their inner VLAN
tags.
tags to the incoming frames received on one port according to their inner VLAN
tags.
Table 60 Advanced Application > VLAN Stacking > Port-based QinQ
LABEL
DESCRIPTION
Port
The port number identifies the port you are configuring.
SPVID
SPVID is the service provider’s VLAN ID (the outer VLAN tag). Enter the
service provider ID (from 1 to 4094) for frames received on this port. See
service provider ID (from 1 to 4094) for frames received on this port. See
for more background information on VLAN ID.
Priority
Select a priority level (from 0 to 7). This is the service provider’s priority level
that adds to the frames received on this port.
that adds to the frames received on this port.
"0" is the lowest priority level and "7" is the highest.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory
when you are done configuring.
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.