ZyXEL Communications 4728F User Manual

 Chapter 45 Maintenance

XGS-4526/4528F/4728F User’s Guide

Click Config 2 to save the current configuration settings to Configuration 2 on 
the Switch.

Alternatively, click Save on the top right-hand corner in any screen to save the 
configuration changes to the current configuration. 

Note: Clicking the Apply or Add button does NOT save the changes permanently. All 

unsaved changes are erased after you reboot the Switch. 

Reboot System allows you to restart the Switch without physically turning the 
power off. It also allows you to load configuration one (Config 1) or configuration 
two (Config 2) when you reboot. Follow the steps below to reboot the Switch.

In the Maintenance screen, click the Config 1 button next to Reboot System to 
reboot and load configuration one. The following screen displays.

Figure 212   Reboot System: Confirmation 

Click OK again and then wait for the Switch to restart. This takes up to two 
minutes. This does not affect the Switch’s configuration.

Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the 
Switch.

Make sure you have downloaded (and unzipped) the correct model firmware and 
version to your computer before uploading to the device.