ZyXEL Communications 4728F User Manual

Chapter 54 Configure Clone

XGS-4526/4528F/4728F User’s Guide

The following table describes the labels in this screen. 

Table 170   Management > Configure Clone 

Source/
Destination

Port

Enter the source port under the Source label. This port’s attributes are 
copied.

Enter the destination port or ports under the Destination label. These are 
the ports which are going to have the same attributes as the source port. 
You can enter individual ports separated by a comma or a range of ports by 
using a dash.

Example: 

• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports. 
• 2-6 indicates that ports 2 through 6 are the destination ports.

Basic 
Setting

Select which port settings (configured in the Basic Setting menus) should 
be copied to the destination port(s). 

Advanced 
Application

Select which port settings (configured in the Advanced Application 
menus) should be copied to the destination ports. 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The 
Switch loses these changes if it is turned off or loses power, so use the 
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.