ZyXEL Communications 4728F User Manual

Chapter 7 System Status and Port Statistics

XGS-4526/4528F/4728F User’s Guide

The following table describes the labels in this screen. 

Table 8   Status 

Port

This identifies the Ethernet port. Click a port number to display the Port 
Details screen (refer to 

).

Name

This is the name you assigned to this port in the Basic Setting > Port 
Setup screen.

Link

This field displays the speed (either 10M for 10 Mbps, 100M for 100 
Mbps, 1000M for 1000 Mbps, and 10G for 10 Gbps) and the duplex (F 
for full duplex or H for half). It also shows the cable type (Copper or 
Fiber) for the combo ports. This field displays Down if the port is not 
connected to any device.

State

If STP (Spanning Tree Protocol) is enabled, this field displays the STP 
state of the port. (See 

 for more information).

If STP is disabled, this field displays FORWARDING if the link is up, 
otherwise, it displays STOP. 

LACP

This fields displays whether LACP (Link Aggregation Control Protocol) has 
been enabled on the port.

TxPkts

This field shows the number of transmitted frames on this port.

RxPkts

This field shows the number of received frames on this port.

Errors

This field shows the number of received errors on this port.

Tx KB/s

This field shows the transmission speed of data sent on this port in 
kilobytes per second.

Rx KB/s

This field shows the transmission speed of data received on this port in 
kilobytes per second.

Up Time

This field shows the total amount of time in hours, minutes and seconds 
the port has been up.

Clear Counter Type a port number, select Port and then click Clear Counter to erase 

the recorded statistical information for that port, or select Any to clear 
statistics for all ports.