Multi-Tech Systems FR111 User Manual

31

This chapter describes the unpacking of the MultiFRAD, cable connec-
tions depending on whether EIA-232D or ITU-T V.35 interface signaling
is used on the data port, and how to configure the unit dependent on
your site situation.  Once the MultiFRAD is configured, then the data port
can be connected to your data port device.

The shipping box contains the MultiFRAD, power adapter, and your
owner's manual.  Inspect the contents for signs of any shipping damage.
If damage is observed, do not power up the unit, contact Multi-Tech's
Technical Support for advice (refer to Chapter 7 - Warranty).  If no
damage is observed, place the MultiFRAD in its final location and verify
the signal levels (EIA-232D or ITU-T V.35) for the data port, and connect
your cables, phone lines, and power supply.

1.  Never install telephone wiring during a lightning storm.

2.  Never install telephone jacks in wet locations unless the jack is

specifically designed for wet locations.

3.  Never touch uninsulated telephone wires or terminals unless the

telephone line has been disconnected at the network interface.

4.   Use caution when installing or modifying telephone lines.

5.   Avoid using a telephone (other than a cordless type) during an

electrical storm.  There may be a remote risk of electrical shock
from lightning.

6.   Do not use the telephone to report a gas leak in the vicinity of the

leak.