Minicom Advanced Systems RJ-45 User Manual
SMART IP LINK
Init String - Initialization string. The default value works with all modern standard
modems connected to a telephone line. For special modems or if connected to a local
telephone switch that requires a special dial sequence to connect to the public
telephone network, change this setting by giving a new string. See the modem's
manual about the AT command syntax.
modems connected to a telephone line. For special modems or if connected to a local
telephone switch that requires a special dial sequence to connect to the public
telephone network, change this setting by giving a new string. See the modem's
manual about the AT command syntax.
Server IP address – This address is used only when connecting to IP Link via a
modem.
modem.
The Client IP (see paragraph below) must be in the same class C subnet. This subnet
should not collide with the Ethernet subnet on the client side and with the Ethernet
subnet on IP Link side.
should not collide with the Ethernet subnet on the client side and with the Ethernet
subnet on IP Link side.
Client IP address - This address is assigned to your client computer during the PPP
handshake. Since it is a point-to-point IP connection virtually every IP address is
possible but ensure it is not interfering with the IP settings of IP Link and your client
computer. The default value will work in most cases.
handshake. Since it is a point-to-point IP connection virtually every IP address is
possible but ensure it is not interfering with the IP settings of IP Link and your client
computer. The default value will work in most cases.
Configuration login
If this option is checked you can only use the port for the initial configuration and no
other function.
If this option is checked you can only use the port for the initial configuration and no
other function.
IPM 220-L (Inline Power Modul)
Check this option if the Peppercon IPM 220-L is connected.
Check this option if the Peppercon IPM 220-L is connected.
Telnet server commands
Click help to list the following commands:
Click help to list the following commands:
cls - Clears screen
quit - Logs out current user and disconnects from the client.
version - Shows all available version numbers
terminal - Starts the terminal passthrough mode. The key sequence `<esc> exit'
switches back to command modus.
switches back to command modus.
Remember! For any of the changes to take effect, click
at the bottom of
the page.
29