Motorola P120 User Manual
Chapter 7
Cajun Campus CLI (Command Line Interface)
80
Cajun P120 User’s Guide
Show Cam Command
Use the
show cam
command to display the CAM table or a specific MAC.
The syntax for this command is:
show cam slot_num | port_num
show cam mac mac_addr [vlan]
Example:
To display dynamic CAM entries for all VLANs:
Console> show cam
Total Matching CAM Entries Displayed = 7
Console>
This example shows routers listed as the CAM entries. When the MAC address
belongs to a router, it is shown by appending an "R" to the MAC address. When a
VLAN is specified, only those CAM entries matching the VLAN number are
displayed.
belongs to a router, it is shown by appending an "R" to the MAC address. When a
VLAN is specified, only those CAM entries matching the VLAN number are
displayed.
Console> show cam mac 00-00-81-01-23-45
Total Matching CAM Entries = 1
Console>
vlan
(Optional) Number of the VLAN. If a VLAN is not specified, all
VLANs are displayed.
VLANs are displayed.
slot_num
Module number (always 1)
port_num
Number of the port.
mac_addr
MAC address.
VLAN
----
DestMAC/Route Des
-----------------
Destination Ports
-----------------
1
00-60-5c-86-5b-81
1/1
1
00-60-2f-35-48-17
1/1
1
00-80-24-f3-47-20
1/2
1
00-60-09-78-96-fb
1/1
1
00-80-24-1d-d9-ed
1/2
1
00-80-24-1d-da-01
1/2
1
08-00-20-7a-63-01
1/1
VLAN
----
Dest MAC/Route
--------------
Destination Ports
-----------------
1
00-00-81-01-23-45
1/9