Alcatel Carrier Internetworking Solutions omniswitch User Manual

Using the CLI

Multiple User Sessions

OmniSwitch 6600 Family Switch Management Guide

page 5-21

In order to list information about your current login session, you may either use the who command and 
identify your login by your IP address or you may enter the whoami command. The following will 
display.

-> whoami

Session number = 4

  User name   = admin,

  Access type = telnet,

  Access port = NI,

  IP address  = 148.211.11.02,

  Read-only rights    = 0x00000000 0x00000000,

  Read-Write rights   = 0xffffffff 0xffffffff,

  Read-only domains   = None,

  Read-only families  = ,

  Read-Write domains  = All ,

  Read-Write families = , 

This display indicates that the user is currently logged in as session number 4, under the username 
“admin,” using a Telnet interface, from the IP address of 148.211.11.02.

The session number assigned to the user.

User name.

Type of access protocol used to connect to the switch. 

Switch port used for access during this session.

User IP address.

The hexadecimal value of privileges configured for the user. 

The hexadecimal value of privileges configured for the user. 

The command domains available with the user’s read-only access. See 
the table beginning on 

 for a listing of valid domains.

The command families available with the user’s read-only access. See 
the table beginning on 

 for a listing of valid families. 

The command domains available with the user’s read-write access. See 
the table beginning on 

 for a listing of valid domains. 

The command families available with the user’s read-write access. See 
the table beginning on 

 for a listing of valid families.