Allied Telesis GS900/5E User Manual
Chapter 2: Installation
36
Powering On the Switch
To apply power to the AT-GS900/16 and AT-GS900/24 switches, perform
the following procedure:
the following procedure:
1. Apply AC power to the switch by plugging the power cord into the AC
power connector on the back panel of the unit, as illustrated in
Figure 13.
Figure 13.
Warning
Power cord is used as a disconnection device: To de-energize
equipment, disconnect the power cord. E3
equipment, disconnect the power cord. E3
Figure 13. Connecting the AC Power Connector to Switch
2. Plug the other end or the power cord into a wall outlet.
3. Verify that the POWER LED is green. If the LED is OFF, refer to
The switch is ready for network operations.
100-240
VAC
~
612