Allied Telesis X610-24TS User Manual

x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide

49

The x610-24Ts-POE+, x610-24Ts/X-POE+, x610-48Ts-POE+ and 

 

x610-48Ts/X-POE+ switches are supplied with a factory installed blank 
panel on the power supply slot. An AT-PWR250 (250W - AC or DC), 
AT-PWR800 (800W), or a AT-PWR1200 (1200W) power supply can be 
installed in these switches. These power supplies are illustrated in 

 

Figure 24, Figure 25 on page 50, Figure 26 on page 50 and Figure 27 on 
page 50.

Note that the AT-PWR250 supplies system power only to the switch. 
Either an AT-PWR800 or an AT-PWR1200 is required to supply power to 
the PoE+ ports in addition to system power to the switch.

Warning
Do not hot swap the power supply modules. Always disconnect the 
AC cord before the power supply module is removed and ensure the 
power supply module is correctly installed before reconnecting the 
AC cord.

When installed, the AT-PWR1200 Module extends 5.6 cm (2.2 in.) 
from the back panel of the chassis.

The model of power supply that is installed determines the maximum 
number of PoE+ ports that are supported on the switch. The maximum 
number of PoE+ and PoE ports supported on the switch, depending on the 
power supply model installed, is described in “Power Capacity” on 
page 57.

2196

Figure 24. AT-PWR250 AC Power Supply