Allied Telesis X3112 User Manual
Chapter 2: Installation
78
Installing an XFP
Transceiver
To install an XFP transceiver in the AT-SBx31XZ4 Line Card, perform the
following procedure:
following procedure:
1. Remove the dust plug from a transceiver slot on the switch. Refer to
Figure 52. Removing an XFP Dust Plug
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Position the transceiver with the label facing down.
4. Slide the transceiver into the slot until it clicks into place, as shown in
Figure 53. Installing an XFP Transceiver
5. Repeat this procedure to install other XFP transceivers.
installation cabling guidelines in the XFP transceiver ports.
For XFP optical and cabling specifications, consult the XFP module
data sheet available at www.alliedtelesis.com. Refer to “Where to Find
Web-based Guides” on page 13 for information about how to navigate
to this information.
data sheet available at www.alliedtelesis.com. Refer to “Where to Find
Web-based Guides” on page 13 for information about how to navigate
to this information.
3
5
7
SBx3
1XZ4
0
1
2
3
XFP
XFP
XFP
XFP
10G LIN
K /
ACT
POR
T ACTIVI
TY
3
5
7
SBx31XZ4
0
1
2
3
XFP
XFP
XFP
XFP
10G LIN
K /
ACT
POR
T ACTIVITY
1913