Allied Telesis X8106 User Manual

SwitchBlade x8106 Chassis Switch Installation Guide

151

This section contains instructions on how to power on the AT-
SBxPWRSYS1 DC Power Supply. For installation instructions, refer to 
“Installing the AT-SBxPWRSYS1 DC Power Supply” on page 103.

The power supply unit has a ground connection and positive and negative 
DC terminals. You may install the ground and power lead wires with the 
terminal lugs that come with the unit or with bare wire. The wire 
requirements are slightly different for terminal installation versus bare wire 
installation. Here are the wire requirements if you are using the terminal 
lugs that come with the power supply:



Two 8 AWG stranded power wires (not provided)



One 10 AWG stranded grounding wire (not provided)

Here are the wire requirements for bare wire installation:



Two 8 AWG solid or stranded power wires (not provided)



One 10 AWG solid or stranded grounding wire (not provided)

Here is a list of the required tools:



Crimping tool (not provided)



8 mm wrench (not provided)



#1, #2, and #3 Phillips-head screwdrivers (not provided)



#3 Phillips-head 30 to 40 inch-lbs Phillips-head torque screwdriver 
(optional - not provided)

Here are the procedures for powering on the AT-SBxPWRSYS1 DC 
Power Supply:













