Allied Telesis X610-24SPS/X User Manual

Page of 128
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
53
AT-LBM (Loop Back) Module
The x610-48Ts/X and x610-48Ts/X-POE+ switches are shipped from the 
factory with an AT-LBM module installed in the expansion slot on the rear 
panel, as shown in Figure 29. This module is factory installed for the 
non-stacking configuration. It provides the capability for a full line rate, 
non-blocking switching configuration when there are connections on the 
x610-48Ts/X and x610-48Ts/X-POE+ switches to all 44 copper ports, two 
SFP ports, and two SFP+ ports. If you need to configure the switch for 
stacking, you may install a VCStack stacking module in place of the 
AT-LBM Module.
PO
WER SUPPL
Y
RPS 
READY
RPS INPUT
56V/18A MAX    12V/21A MAX
STACKING
WARNING
This unit may have more than one power input. To reduce the risk of 
electric shock, disconnect both A/C and RPS inputs before servicing 
unit.
AT-LBM
Figure 29. AT-LBM Module Installed in x610-48Ts/X Expansion Slot
Note
The AT-LBM module is very similar to a blank panel in its outward 
appearance except that it is marked with the “AT_LBM” model name 
in the upper left-hand corner of the faceplate.
 
 
If the AT-LBM module is replaced with either an AT-StackXG or 
 
AT-x6EM/XS2 stacking module, the switching configuration is no 
longer non-blocking.