Allied Telesis X610-24SPS/X User Manual

Chapter 3: Installing the Hardware

78

This section applies to the fixed power supplies installed in the x610-24Ts, 
x610-24Ts/X, x610-48Ts, and x610-48Ts/X switches and to the 
AT-PWR250 and AT-PWR800 power supply modules.

The AT-PWR1200 power supply does not have a retaining clip.

Perform the following procedure to install the power cord retaining clip on 
the switches:

1. Locate the power cord retaining clip, shown in Figure 38.

Figure 38. Power Cord Retaining Clip

2. Install the clip on the AC power connector on the rear panel of the 

switch. With the ‘u’ of the clip facing down, press the sides of the clip 
toward the center and insert the short ends into the holes in the 
retaining bracket, as shown in Figure 39.

Figure 39. Inserting the Retaining Clip into the Retaining Bracket

You are now ready to install the switches in the equipment rack, as 
explained in the next procedure.