Allied Telesis AT-9000/52 User Manual
Chapter 10: Setting Static Port Trunks
122
Modifying the Static Trunk Settings
Review the following information if you are adding ports to an existing
trunk:
trunk:
If the port you are adding is the lowest numbered port in the trunk, its
parameter settings overwrites the settings of the existing ports in the
trunk. Therefore, check if its settings are appropriate before adding it
to the trunk. If the new port is not the lowest numbered port, its port
settings are changed to match the settings of the existing ports in the
trunk.
parameter settings overwrites the settings of the existing ports in the
trunk. Therefore, check if its settings are appropriate before adding it
to the trunk. If the new port is not the lowest numbered port, its port
settings are changed to match the settings of the existing ports in the
trunk.
If the new port added to a trunk is already a member of another static
trunk, you must first remove it from its current trunk assignment.
trunk, you must first remove it from its current trunk assignment.
To add or delete member ports from a static port trunk, do the following:
1. Select the Switching tab.
The Switching tab is displayed. See Figure 19 on page 58.
2. From the Switching tab, select Link Aggregation.
For an example of the Link Aggregation selection, see Figure 41 on
page 117.
page 117.
3. Move the cursor to the right and select Static Trunks.
The Static Trunks page is displayed. See Figure 42 on page 117.
4. From the Static Trunks page, click Edit.