Allied Telesis AT-S63 User Manual
Chapter 27: Internet Protocol Version 4 Packet Routing
300
Section VII: Routing
Supported Platforms
This feature is supported on the following switches:
Layer 2+ Models
– Not supported
– Not supported
Basic Layer 3 Models
– AT-9424T
– AT-9424Ts
– AT-9424Ts/XP
– AT-9448T/SP
– AT-9448Ts/XP
– AT-9424T
– AT-9424Ts
– AT-9424Ts/XP
– AT-9448T/SP
– AT-9448Ts/XP
Stack of Basic Layer 3 Switches and the AT-StackXG Stacking Module
– Not supported
– Not supported
Note
You can create one routing interface on the Layer 2+ models and a
stack of Basic Layer 3 switches to serve as the IP configuration for
the device. For further information, refer to “Routing Interfaces and
Management Features” on page 318 and “AT-9408LC/SP
AT-9424T/GB, and AT-9424T/SP Switches” on page 322.
stack of Basic Layer 3 switches to serve as the IP configuration for
the device. For further information, refer to “Routing Interfaces and
Management Features” on page 318 and “AT-9408LC/SP
AT-9424T/GB, and AT-9424T/SP Switches” on page 322.
This feature can be managed from the following management interfaces:
Command line interface
Menus interface
Note
You can configure routing interfaces from the menus interface, but
not static routes or RIP. To configure all the feature’s components,
you must use the command line interface.
not static routes or RIP. To configure all the feature’s components,
you must use the command line interface.