Allied Telesis AT-S111 User Manual
Chapter 2: System Configuration
32
Configuration of IP Address, Subnet Mask and Gateway Address
This procedure explains how to change the IP address, subnet mask, and
gateway address of the switch. Before performing the procedure, note the
following:
gateway address of the switch. Before performing the procedure, note the
following:
A gateway address is only required if you want to
remotely manage the device from a management
station that is separated from the switch by a router.
remotely manage the device from a management
station that is separated from the switch by a router.
To configure the switch to automatically obtain its IP
configuration from a DHCP server on your network, go
to “DHCP Client Configuration” on page 47.
configuration from a DHCP server on your network, go
to “DHCP Client Configuration” on page 47.
To change the switch’s IP configuration, perform the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
The System folder expands.
2. From the System folder, select IP Setup.
The IP Setup Page is displayed. See Figure 6.
Figure 6. IP Setup Page
3. Change the IP configuration parameters by observing or entering new
information in the following fields:
System MAC Address - This parameter displays the MAC
address of the switch. You cannot change this parameter.
address of the switch. You cannot change this parameter.
System IP Address - Displays the current IP address of the
switch. To change the IP address, enter a new IP address.
When DHCP is enabled, you cannot change this parameter.
switch. To change the IP address, enter a new IP address.
When DHCP is enabled, you cannot change this parameter.
System Subnet Mask - Displays the current subnet mask of the
switch. To change the subnet mask, enter a new subnet mask.
When DHCP is enabled, you cannot change this parameter.
switch. To change the subnet mask, enter a new subnet mask.
When DHCP is enabled, you cannot change this parameter.