Allied Telesis AT-S111 User Manual
Chapter 28: Rebooting the AT-GS950/48PS
338
Switch Reboot
The following procedure outlines how to reboot your AT-GS950/48PS
switch.
switch.
Caution
This procedure reboots the switch and reloads the AT-S111
Management software configuration from flash memory. Insure that
your current configuration is saved before rebooting the switch by
selecting Save Configuration to Flash from the main menu on the
left side of the page to permanently save your changes.
This procedure reboots the switch and reloads the AT-S111
Management software configuration from flash memory. Insure that
your current configuration is saved before rebooting the switch by
selecting Save Configuration to Flash from the main menu on the
left side of the page to permanently save your changes.
All configuration parameters that have not been previously saved
are lost. After the switch is reboots, they are reset to the values
stored in the flash memory.
are lost. After the switch is reboots, they are reset to the values
stored in the flash memory.
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
1. From the main menu on the left side of the page, select the Tools
folder.
The Tools folder expands.
The Tools folder expands.
2. From the Tools folder, select Reboot.
The Factory Default Reset/Reboot Page is displayed. See Figure 133.
Figure 133. Factory Default Reset/Reboot Page
3. Go to the lower part of the page to the Reboot section.