Allied Telesis AT-SBX3165 User Manual
SwitchBlade x3112 Installation Guide
83
Installing the Chassis Blank Panels
Ten blank panels are supplied with the AT-SBx3112 Chassis. These
panels must be installed in to insure proper airflow through out the
chassis. To install the blank panels, perform the following procedure:
panels must be installed in to insure proper airflow through out the
chassis. To install the blank panels, perform the following procedure:
1. Install a blank panel in each vacant slot from slots 0 to 11 where a line
card has not been installed.
2. Align the two thumb screws on the blank panel with the mounting holes
on the front panel rails of the chassis.
3. Finger tighten the two thumbscrews to attach the blank panel to the
chassis.
4. With a # 2 Phillips head screw driver, torque both thumbscrews to
.56 Nm (5 lb-in) maximum.
5. Repeat steps 2 through 4 for the remaining vacant slots.
6. Store any unused blank panels in a secure place for future use.