Intermec PF2i User Manual

From the inside of the electronics compartment, insert the antenna 

connector through the round hole in the rear plate and lock it with 

the washer and nut on the outside.
Fit the antenna to the connector of the antenna cable and bend the 

hinge so the antenna points straight up. 
From the outside, insert the thin end of the light guide through the 

small hole next to the antenna on the rear plate. Press the clear plastic 

“lamp” in place. Connect the other end to the black plastic socket 

(D1) at the top of the EasyLAN adapter board. Secure it with the 

cable tie through the hole at the upper edge of the CPU board.
Put back the cover over the electronics compartment. 
Connect the power cord and switch on the power.
Enter Setup Mode and print the test label “Hardware Info” in 

Fingerprint or “HW” in IPL to see if the printer detects the EasyLAN 

Wireless interface board. For information on how to enter the Setup 

Mode and print test labels, refer to the printer’s user's guide.

EasyLAN adapter 

board

Light guide

Cable clips

#T20 Torx screw 

and spacer

Antenna

cable

Cable tie

Antenna