Sun Microsystems 120 User Manual
9-2
Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
9.1
Monitoring the System From Solaris
To use the Lights-Out Management (LOM) facilities either remotely or locally, you
need a terminal connection to the Serial A/LOM port on the server (see Chapter 6).
need a terminal connection to the Serial A/LOM port on the server (see Chapter 6).
There are two ways of interrogating the LOM device or of sending it commands to
perform.
perform.
■
One is by executing LOM commands from the
lom>
shell prompt. For
information about how to do this, see Chapter 8.
■
The other is by executing LOM-specific Solaris commands from the Solaris
prompt. These commands are described in this chapter.
prompt. These commands are described in this chapter.
The Solaris commands described in this section are all available from the main
Solaris # prompt. They run a utility called
Solaris # prompt. They run a utility called
/usr/sbin/lom
.
Where appropriate, the command lines given in this section are accompanied by
typical output from the commands.
typical output from the commands.
9.1.1
Viewing Online LOM Documentation
●
To view the manual pages for the LOM utility, type:
9.1.2
Checking the Power Supply Unit (
lom -p
)
●
To check that the input lines and the output line for the power supply unit are
working normally, type:
working normally, type:
# man lom
# lom -p
PSUs:
1 OK
#