Sun Microsystems 1290 User Manual

Netra 1290 Server Installation Guide • May 2006

Note –

It is the installer’s responsibility to ensure that the cabinet has sufficient

electrical power and redundancy to handle the required installation.

■

If the server is mounted in an unpowered cabinet:

a. Connect power cords from Source A on the server to the customer-supplied

power source A circuit breakers.

b. Connect power cords from Source B on the server to the customer-supplied

power source B circuit breakers.

■

If the server is mounted in a powered cabinet:

a. Connect power cords from Source A on the cabinet to the customer-supplied

power source A circuit breakers and from Source B on the cabinet to the
customer-supplied power source B circuit breakers.

Refer to the installation guide that came with the cabinet for instructions on
cabinet power cabling.

b. Connect power cords from Source A on the cabinet to Source A on the server

and from Source B on the cabinet to the Source B on the server.

Refer to the installation guide that came with the cabinet for instructions on
cabinet power cabling.

Connecting Consoles to the System
Controller

This section contains the following topics:

■

“To Connect the Initial Administrative Console” on page 35

■

“To Connect the Administrative Console” on page 36

The system controller (SC) provides the Lights-Out Management (LOM) functions,
which include power-on sequencing, executing module power-on self-tests (POST),
environmental monitoring, fault indication, and alarms.

The LOM command-line interface, the Solaris console, and the OpenBoot™ PROM
console are accessed by connecting an administrative console to either serial port A
or the 10/100BASE-T LOM Ethernet port. The administrative console can be any
external input device (laptop computer or workstation) connected to either of these
ports.