Lantronix EDS16PS User Manual

2. Enter or modify the following settings:

Enter the password for Telnet access.

Enter the password for access to the Command Mode Enable level. 

There is no password by default.

Enter a string to terminate a connect line session and resume the 

CLI. Type <control> before any key the user must press when 

holding down the Ctrl key. An example of such a string is 
<control>L.

Set an Inactivity Timeout value so the CLI session will disconnect if 

no data is received after the designated time period. Default is 15 

minutes.  Enter  a value of 0 to disable.

Select Disabled to disable Telnet access. Telnet is enabled by 

default.

Enter the Telnet port to use for Telnet access. The default is 23.

Maximum number of simultaneous Telnet sessions.  The default is 

3 and the maximum is 10.

Select Disabled to disable SSH access. SSH is enabled by default.

Enter the SSH port to use for SSH access. The default is 22.

Maximum number of simultaneous SSH sessions. The default is 3 

and the maximum is 10.