Lantronix EDS16PS User Manual
3: Installation of EDS8PS and EDS16PS
EDS User Guide
28
1. Press and hold the reset button for about 3 seconds. The status LED blinks quickly.
2. When the fast blinks stop, release the button. When the unit reboots, the status LED changes
2. When the fast blinks stop, release the button. When the unit reboots, the status LED changes
from a fast blink to a solid ON.
Restore factory defaults:
1. Press and hold the reset button for about 11 seconds. The LED blinks quickly for about 3
seconds, then comes on for about 5 seconds, then blinks slowly for about 2 seconds.
2. When the slow blinks stop, release the button.
Installing the EDS8/16PS
Finding a Suitable Location
You can install the EDS8/16PS either in a shelf or as a desktop unit.
If using AC power, avoid outlets controlled by a wall switch.
Connecting the EDS8/16PS
All EDS serial ports support RS-232 devices.
Connect the EDS8/16PS to one or more serial devices.
1. Power off the serial devices.
2. Attach a CAT 5 serial cable between the EDS8/16PS and your serial device. See the
2. Attach a CAT 5 serial cable between the EDS8/16PS and your serial device. See the
, for a list of cables and adapters
you can use.
3. Connect an Ethernet cable between the EDS8/16PS Ethernet port and your Ethernet network.
4. Insert the power cord into the back of the EDS8/16PS. Plug the other end into an AC wall
4. Insert the power cord into the back of the EDS8/16PS. Plug the other end into an AC wall
outlet.
5. Power up the serial devices.