DELL 3000i User Manual
Setting Up Your iSCSI Storage Array
53
discovery.sendtargets.auth.password = password_1
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in = test1234567890
If you are using SLES10 SP1 via the GUI
1 Select Desktop→ YaST→ iSCSI Initiator.
2 Click Service Start, then select When Booting.
3 Select Discovered Targets, then select Discovery.
4 Enter the IP address of the port.
5 Click Next.
6 Select any target that is not logged in and click Log in.
7 Choose one:
2 Click Service Start, then select When Booting.
3 Select Discovered Targets, then select Discovery.
4 Enter the IP address of the port.
5 Click Next.
6 Select any target that is not logged in and click Log in.
7 Choose one:
•
If you are not using CHAP authentication, select No Authentication. Proceed to step 8.
or
•
If you are using CHAP authentication, enter the CHAP username and password. To enable
Mutual CHAP, select and enter the Mutual CHAP username and password.
Mutual CHAP, select and enter the Mutual CHAP username and password.
8 Repeat step 7 for each target until at least one connection is logged in for each controller.
9 Go to Connected Targets.
9 Go to Connected Targets.
10 Verify that the targets are connected and show a status of true
.