Gateway 6400 User Manual
Setting the configuration switches
71
Once the switch is set to the ON position, the system passwords will be cleared
when the system goes through the POST routine. When this occurs, the
following error message will appear:
when the system goes through the POST routine. When this occurs, the
following error message will appear:
CMOS checksum bad
Press F1 to run Setup
Press F2 to load default values and continue
Press F2 to load default values and continue
After selecting the appropriate option, enter any required information and
continue. When you turn off the system again, open the case, set the switch
back to the OFF position, then close the case.
continue. When you turn off the system again, open the case, set the switch
back to the OFF position, then close the case.
05032.book Page 71 Monday, July 10, 2000 11:43 AM