Gateway 7210 User Manual

Introduction          

If the server does not operate correctly, re-read the instructions for the 
procedures you have performed. If an error occurs within an application, refer 
to the documentation supplied with the software. This section identifies 
solutions to some possible problems.

Before turning on the system, make sure that:

■

The power cord is connected to the AC power-in connector and an AC 
outlet.

■

The AC outlet is supplying power.

■

If a power strip is used it is turned on, setting the circuit breaker.

■

The voltage selection switch on the system power supply reflects the 
proper voltage.

If the server is not operating correctly, the BIOS may contain an invalid 
configuration parameter. Open the BIOS Setup utility and check your 
configuration settings. (See “About the BIOS Setup utility” on page 83.)

8505945.book  Page 105  Thursday, March 9, 2000  2:13 PM