Gateway 7210 User Manual

Processors          

Gently press the DIMM into the socket until it is firmly seated. Inserting 
the DIMM automatically locks the socket clamps on each end of the 
DIMM.

Close the case. (See “Closing the case” on page 27.)

Reconnect the peripherals and the power cord, then turn on the system.

The system is compatible with the Intel

®

 Pentium

®

 III 600 MHz and faster 

processors with 100 MHz front-side bus (FSB). As many as two processors may 
be installed in the system. The voltage regulator modules for both processors 
are built into the system board and you do not need to install additional 
VRMs.

When replacing a processor, order a processor upgrade kit from Gateway. The 
kit includes the processor, a fansink or heatsink, and a disposable grounding 
wrist strap.

Turn off the system and disconnect the power cord and all external 
peripheral devices.

Open the case by following the instructions on page 23. (See “Preventing 
static electricity discharge” on page 22.)

Disconnect the processor fan cable from the processor fan connector on 
the system board.

Place the head of a flat-bladed screwdriver behind the tab on one side 
of the processor retention bracket holding the processor to be removed.

A heatsink or fansink must be installed on each processor. 
Installing a processor without a heatsink or fansink could 
result in damage to, or failure of, the processor.

8505945.book  Page 53  Thursday, March 9, 2000  2:13 PM