Fujitsu TX200FT S2 User Manual

Validation interval at automatic shutdown

This setting is required for the use of UPS.

For details about various settings, refer to "3.4 UPS Settings" in the "User's Guide". The numbers in brackets ( ) are setting
examples.

Item

Actual Setting Parameters

Time

Validation interval from the power failure

to the start of FTvirtual Server shutdown

"Power Failure" - "When power fails, begin a shutdown

procedure:" - "After UPS has been on battery for" in

Device Properties.

minutes

(1 min)

Validation interval from the start of FTvirtual

Server shutdown to the start of CoServer

shutdown (Command file execution time)

Select Device properties "Shutdown Sequence" -

"Configure Shutdown Sequence" - "Next" - "OS" and

then "Delay".

minutes

(3 mins)

Validation interval from the start of CoServer

shutdown to UPS power off (time required for

OS shutdown)

Select Device properties "Shutdown Sequence" -

"Configure Shutdown Sequence" - "Next" - "OS" and

then "Duration".

minutes

(1 minute

30 seconds)

Total

minutes

seconds

(5 minutes

30 seconds)

Network configuration

CoServer Link1, CoServer Link2, Virtual Network1 and Virtual Network2 are internal network settings. Normally modifi-

cations are not required.

However, when there is a conflict with an external network, refer to "3.2 Network Functions" in the "User’s Guide" before

setting. Figures in the brackets ( ) are default values.

Item

FTvirtual Server

IP address

Subnet mask

Computer name
Local area connection (FTvirtual Server LAN)

. . .

Virtual Network1

(192 . 168 . 181 . 81)

(255 . 255 . 255 . 252)

Virtual Network2

(192 . 168 . 181 . 85)

(255 . 255 . 255 . 252)

Item

CoServer1 (FT1)

CoServer2 (FT2)

IP address

Subnet mask

IP address

Subnet mask

Computer name
CoServer Management

(CoServer LAN)

. . .

CoServer Link1

(192 .168 .181 . 89)

(255 .255 .255 .252)

(192 .168 .181 . 90)

(255 .255 .255 .252)

CoServer Link2

(192 .168 .181 . 93)

(255 .255 .255 .252)

(192 .168 .181 . 94)

(255 .255 .255 .252)

Virtual Network

(192 .168 .181 . 82)

(255 .255 .255 .252)

(192 .168 .181 . 86)

(255 .255 .255 .252)

When setting, the FTvirtual Server LAN adapter appears (Redirected 0) on the CoServer, but it is reserved because it is

used by the FTvirtual Server.

Do not bind internet protocol (TCP/IP) and do not set IP addresses or subnet masks to these adapters on the CoServer.

Set the FTvirtual Server LAN IP address and the subnet mask on the FTvirtual Server.