Fujitsu N800 User Manual
104
U41243-J-Z156-1-76
Boards in hot-plug PCI slot
System expansions
8.5.2
Adding a PCI board
Figure 29: Removing the PCI slot cover
Ê
Remove the hot-plug PCI cover (see the section “Removing/mounting the
PCI bus hot-plug cover” on page 87).
PCI bus hot-plug cover” on page 87).
Ê
Release the PCI locking mechanism for the desired slot and remove the slot
partition.
partition.
V
CAUTION!
Any unoccupied PCI slots must be equipped with partitions to ensure
that the electromagnetic emission properties of the server are
observed and that the server components are cooled properly.
that the electromagnetic emission properties of the server are
observed and that the server components are cooled properly.
Ê
Start the PCI hot-plug utility from the Control Panel.
Ê
If necessary, set jumpers and switches on the new board according to the
instructions supplied by the manufacturer.
instructions supplied by the manufacturer.
Ê
Place the new board in the bay and press it carefully into the corresponding
slot.
slot.