Fujitsu N800 User Manual
110
U41243-J-Z156-1-76
Memory expansion
System expansions
8.7.1
Installing DIMMs
A single memory module will support DIMM population in various configurations
(including empty sockets). However, if fewer than 16 DIMMs are installed on a
module, the preferred population order is in groups of four sockets (Jx) (see also
figure 32 on page 109):
(including empty sockets). However, if fewer than 16 DIMMs are installed on a
module, the preferred population order is in groups of four sockets (Jx) (see also
figure 32 on page 109):
This recommendation ensures optimum performance, signal integrity and
cooling.
cooling.
I
The maximum capacity is limited to 16 GB if only one module is installed.
The capacity increases to 32 GB if two modules are used.
The capacity increases to 32 GB if two modules are used.
BIOS automatically detects, sizes and initializes memory (conventional and
extended memory) according to the type, size and speed of the installed DIMMs
and reports memory size and allocation to the system via the configuration
registers.
extended memory) according to the type, size and speed of the installed DIMMs
and reports memory size and allocation to the system via the configuration
registers.
V
CAUTION!
Observe the safety information and the information on handling electro-
static-sensitive components in the chapter “Important notes” on page 11.
static-sensitive components in the chapter “Important notes” on page 11.
Use extreme care when installing a DIMM. Too much pressure can
damage the ejector levers.
damage the ejector levers.
The DIMMS are equipped with coded connectors so that they cannot be
installed incorrectly.
installed incorrectly.
Ê
Remove the DIMM from its antistatic package.
Step
Occupied sockets
1
J1-J5-J9-J13
2
J2-J6-J10-J14
3
J3-J7-J11-J15
4
J4-J8-J12-J16