Fujitsu RX200 S2 User Manual

156

Chapter 5 Operations after OS Installation

Click [OK].

When the Teaming setting is completed, the following virtual adapter will be created.

• Intel(R) Advanced Network Services Virtual Adapter

Upper protocols will be bound with the main virtual adapter.

You cannot bind them with the LAN card consisting of a Team.

The IP address can be set in the main virtual adapter.

5.6.4 VLAN

■ Notes

When using a VLAN, note the following points.

• You can only have "NetBIOS over TCP/IP" enabled for up to four VLANs in the whole system.

• On a VLAN, do not use protocols other than TCP/IP.

• You can only set ten or less VLANs to a LAN port.

• When adding or deleting a VLAN, always use "Intel(R) PROSet". Do not disable or delete a VLAN

from the [Device Manager] or [Network and Dial-up Connections].

■ VLAN Setup Procedure

Start up "Intel

PROSet". The procedure differs depending on the OS being

used.

For Windows Server 2003

1. Click [Start] → [Control Panel] → [Intel(R) PROSet].

For Windows 2000 Server

1. Click [Start] → [Settings] → [Control Panel].

The [Control Panel] window appears.

2. Start up "Intel(R) PROSet".

Select a LAN card to setup a VLAN and right-click it.

Click [Add VLAN]. The following message may be displayed at the time. In such

a case, click [Yes].

Specify [ID] and [Name]. Then click [OK].

The [ID] should be identical with the switch setting.

The [Name] does not need to be identical with the switch setting.

Repeat Step 3 through 5 to set respective VLANs.

You need to connect with the switch that supports IEEE

VLANs (802.1Q). Do you want to enable QOS Packet Tagging?