Fujitsu RX200 S2 User Manual

23

PRIMERGY RX200 S2 User’s Guide    

1

Overview

o USB connector (

)

Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).

p 3.5-inch storage bay

Contains an internal hard disk unit.

q Inlet

AC power cables are plugged in.

1.3.2 Server (Rear View)

a LAN connector A (

)

An Unshielded Twisted Pair (UTP) cable is plugged in. For 1000Mbps connection, a cable 

conforming to category 5 enhanced is required.

The meanings of the two LED are shown in the table below.

The left LED may light green when no LAN cable is connected. This is not a failure. When a 

LAN cable is connected, the LED operates as shown in the table above. If the LED does not light 

or blink though a LAN cable is connected, the server may have a failure.

b LAN connector B (

)

This is a PCI connector. The applicable cable and meanings of the LEDs are the same as those for 

LAN connector A.

c Rear maintenance LED (

)

This LED lights amber when the server is not turned on (standby mode). When the server is 

turned on and the ServerView is installed, this LED lights amber during the logical drive 

initialization/rebuild of the onboard disk array controller. When an error is detected in the server 

components while the server is turned on, it also lights or blinks amber.

If this LED lights or blinks except for drive initialization or rebuild while the server is turned on, 

contact an office listed in the "Contact Information" section of the "Start Guide".

table: LAN Status

LED 

location

LED status

Connection status

Left

Lights green

Link is being established.

Blinks green

Data is being transferred.

Off

Link is not established.

Right

Lights amber

Connection is established at 1000Mbps.

Lights green

Connection is established at 100Mbps

Off

Connection is established at 10Mbps or 
the LAN is not connected.