Fujitsu RX200 S2 User Manual

297

PRIMERGY RX200 S2 User’s Guide    

Ap
pend

ix

C

Remote Control Function and 

Console Redirection

When a personal computer (PC) is connected to the serial port of this server with a 

cross cable, the server can be turned on/off or reset from the PC via RS-232C 

(remote control function). Console redirection can be performed in the same manner.

The remote control and console redirection functions can be switched between each other.

Perform the following procedures to use these two functions.

• Connecting the server to a PC

• Setting the server using the Remote Control Utility

 To use the reset function via RS-232C, the terminal software on the PC must have the same 

communication speed and flow control mode settings as those on the Remote Control Utility menu.

 When both remote control function and BIOS console redirection are used, perform the following 

procedures in the BIOS Setup Utility.

• On the [Peripheral Configuration] submenu of the [Advanced] menu, change [Serial Multiplexer] to 

[Shared].
"8.2.6 Peripheral Configuration Submenu" (pg.216)

• On the [Console Redirection] submenu of the [Server] menu, change [Console Redirect] to 

[Enabled].
"8.2.16 Console Redirection Submenu" (pg.230)