Fujitsu RX200 S2 User Manual

Chapter 2 Checking before OS Installation

2.3.2 Notes on Configuring RAID

Take the following notes when you configure a RAID system.

■ Hardware Configuration

• Only internal hard disk units can be used.

• Be sure to use hard disk units of the same model and with the same capacity.

• Two hard disk units can be configured for installation. An array configuration cannot be established

with only one unit.

• The only RAID level configurable with this server is RAID1.

When the OS is installed using ServerStart, only one RAID card can be installed. If you need more

cards, install them after OS installation.

■ Checking before OS Installation

• When a RAID-configured disk is used

Used hard disk units can contain unnecessary partition or array configuration information that can

cause unforeseeable problems.

Before connecting a used hard disk unit to this server, connect it to a different system and perform

low-level formatting on the hard disk unit.For the low-level formatting procedure, refer to the manual

supplied with the system used for formatting.When performing low-level formatting on a hard disk

• Number of disk units

If only one hard disk unit is set, installation with ServerStart causes an error and will be aborted.Be

sure to configure two units.

2.3.3 Notes on a Multiple LAN Adapter Configuration

Using the OS installation wizard of ServerStart, you can configure multiple LAN adapters (network

adapters) on the system. However, there are the following limitations.

●

Adapter Numbers

To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and

enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the

order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always

applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are

configured as intended.