Fujitsu RX200 User Manual
44
Options Guide
Installing the RemoteView Service Board S2 LP RemoteView Components
Figure 24: Installing the RSB S2 LP
Ê
Remove the slot cover.
I
Keep the slot cover for future use. If you remove the RSB S2 without
installing a new one, you must reinstall the slot cover to comply with
EMC regulations (regulations on electromagnetic compatibility) and
to satisfy cooling requirements and fire protection measures.
installing a new one, you must reinstall the slot cover to comply with
EMC regulations (regulations on electromagnetic compatibility) and
to satisfy cooling requirements and fire protection measures.
Ê
Install the RSB S2 LP in the low-profile PCI slot (#2) of the riser card. The
procedure is described in the section “Installing controllers” on page 40.
procedure is described in the section “Installing controllers” on page 40.
Ê
Plug the power cable into the CN7 connector of the system board.
I
The position of the connectors is described in the “Technical Manual
of the System Board D1790”.
of the System Board D1790”.
Ê
Plug the data cable into the CN6 socket (IPMB) of the system board.
Ê
Install the riser card holder (see page 41).
Ê
Close the server, plug in the power plugs, and switch on the server as
described in the chapter “Completion” on page 45f.
described in the chapter “Completion” on page 45f.
Low-profile slot (# 2)