Nortel Networks 555-4001-135 User Manual
Engineering guidelines 39
Nortel Integrated Conference Bridge Service Implementation Guide
•
An ICB card configured to the maximum capacity of 32 ports and 10
simultaneous conferences requires 87 ACD DNs and 32 TNs/LENs
as follows:
simultaneous conferences requires 87 ACD DNs and 32 TNs/LENs
as follows:
— one ACD DN assigned to the ICB card
— 32 TNs/LENs assigned to the 32 ports (1 PDN and 1 SDN for
each TN/LEN; these can be internal DNs – non-DID)
— 20 ACD DID DNs (10 DN pairs) for dialing into the potential
conferences
Note: For single-number access, replace this with 1 DN.
— 1 DN for TUI access
Full 62-port dual-card conferencing, using the direct meeting access
method, requires the following:
method, requires the following:
•
Two ICB cards and six ACD groups as follows:
— 64 ACD agents (32 for each card), non-DID
— 64 secondary DNs for these agents, non-DID
— 36 DNs for simple conferences (9 pairs in each card)
Note: For single-number access, replace this with 2 DNs (1
for each card).
for each card).
— 1 DN for dual-card conference access
— 1 DN for dual-card chairperson access
— 1 DN for the link DN, non-DID
— 1 DN for the transfer DN, non-DID
— 2 DNs for TUI access (1 for each card)
This provides a total of 170 DNs, 40 of which are DID.
•
Assign an Ethernet port to each ICB card with an IP address, subnet
mask, and gateway during installation.
mask, and gateway during installation.
Note: On the CS 2100/Meridian SL-100, verify that there are
enough DS30A links back to the extended peripheral module (XPM)
to handle the traffic.
enough DS30A links back to the extended peripheral module (XPM)
to handle the traffic.