Polycom 14117800 User Manual
68
Preparing KIRK Handset for Use
14117800, Ed.2.6
•
Only use battery type 84743418 (ICP73048) in the 5020 / 5040 Handset. Do not use this battery with other
products. This battery was designed specifically for use with the 5020 /5040 Handset and the charger
ONLY. Improper use of the battery may result in fire hazard.
products. This battery was designed specifically for use with the 5020 /5040 Handset and the charger
ONLY. Improper use of the battery may result in fire hazard.
•
Do not do anything that would cause the battery to short circuit.
•
Do not let the battery or the charger come into contact with conductive metal objects.
Note:
The 4080 Handset is only available in EMEA.
6.3.1 Installing Battery on KIRK 3040 Handsets
1
To install the battery press down the back cover and push it 5 mm towards the
headset plug.
Figure 1
Remove Back Cover from Handset
2
Lift off back cover.
3
Place the battery plug in the slot in the battery box.
4
Insert battery with the label readable.
5
Replace the back cover.
6.4 Installing Battery on KIRK 4020/KIRK 4040/KIRK 4080 Handsets
Note:
The battery is connected to the handset when it is shipped from the factory.
Warning:
The battery in a 4080 Handset must not be removed in a potentially explosive
atmosphere. Only use battery type 84743416 in the 4080 Handset.
1
To change the battery unscrew the plate on the rear of the handset to access the
battery compartment. Use a normal screw driver.
2
Insert the screwdriver into the small crack behind the blind cover and break to open
the handset.