Wizard Ca Co CPT-8061 User Manual

 
 

 
 

 

Appendix B: Settings Worksheet / Miscellaneous 

85

 

 

To upload kernel updates (supplied by CIPHER Labs) to each wireless scanner, 
perform each of the following tasks: 

1. 

Step 6 in Section 4.2.1 (Preparing CPT-8061) provides instructions on how to 
connect the Charging and Communications cradle to the serial port of the PC from 
which the firmware update will be loaded. If you have not already performed each  

of the tasks outlined in Step 6, they must be completed at this time. The PC sends the 
Scan-IT interface software on to each communications cradle via this serial 

connection. The cradle in turn “transmits” the software to the wireless scanner via an 
Infrared laser light emitted from a red window located in the large slot at the top of the 

cradle, to another red window located on the bottom of the scanner unit.

 

2.  Place the CPT-8061 scanner facing forward into the large slot located at the top of the 

Charging and Communications cradle. The metal contacts located on the bottom of the 
scanner unit must make firm connection with the metal prongs located in the large 
slot at the top of the cradle. Leave the nylon hand cord (attached to the lower left 

corner of the scanner) hanging out the left side of the cradle. Make sure the scanner 
is turned off at this point! 

3.  Simultaneously press the <7> and <9> keys and the 

<Power> 

key in the lower right 

front corner of the scanner. Wait for the scanner to beep three times, then turn the 

scanner off by pressing the 

<Power>

 key. 

 

Simultaneously Press <7> + <9> + 

, 

After three beeps, turn scanner off by pressing 

 again