Wasp Bar Code WWS850 User Manual

 

3

 

When you receive your WWS800/850, the battery will be packaged separately. 
Please insert the battery into the bottom of the scanner and lock the battery into 
place by pushing up on the clip. The scanner will beep and the LED will be light 
up when the device is powered on.   

                                

  

 

Please remove the battery to power off the scanner if it will not be used for a 
prolonged period. The LED will be off and the power to the scanner will be 
disconnected. 

 

 

Upon powering up, the scanner will try to establish an RF connection with its base. 
At this stage we need to “pair” the scanner and base. 

Turn the base upside down and you will find 2 labels.  

The first label says “SET CONNECTION” and contains a barcode. The second 
label is the serial number. 

To link the scanner to the base, scan the “SET CONNECTION” barcode label, the 
scanner will beep once then scan the SERIAL number barcode. The scanner will 
beep twice, low then high. When it establishes RF connection with the base the 
scanner will then emit three short ascending beeps. Your “pairing” is established. 

 

 

 

 

 

4

 

There are three methods to charge the battery. One is placing the scanner on the 
base and another is inserting the battery in front of the base, and the other is 
inserting the power supply into the DC Jack at bottom of the scanner. 

 

Place the scanner (with the battery inserted) on the base to charge your scanner. 
When charging, the scanner LED will flash RED. When the battery is fully 
charged, around 4 hours from completely empty battery, the LED stays on solid 
RED.  

      

                      

 

 

Insert the battery in front of the base to charge your battery with the power adaptor 
connected. When charging, the base charging LED will be RED. When the battery 
is fully charged, around 4 hours from completely empty battery, the LED will be 
solid GREEN.