Kodak i800 Series User Manual

 

 

A-61169 July 2003 

5-11 

This section provides procedures for replacing the following parts. Use the 
list below as a guideline for frequency of replacement. 

• 

Feed Module Tires and Separation Roller – tire life will vary 
depending upon paper types, environment and cleanliness. Nominal 
tire life will be approximately 250,000 documents; results will vary. 
Degradation of feeder performance, multiple feeds, stoppages, etc. 
indicate a need to change tires. Change all the tires on the feed 
module and separation roller at the same time. 

• 

Feed Module Separation Roller – it is recommended that you install 
a new feed module approximately every 5th tire change. See the 
checklist included in the Replenishment Kit. Install a new feed module 
and separation roller at the same time. 

• 

Pre-separation Pad – change each time you change the tires on the 
feed module and separation roller. 

• 

Exposure Lamps – it is suggested that all four lamps be replaced 
every 500 hours of operation or as necessary (i.e., as reported by the 
scanner, repeated image calibration failures, etc.) 

• 

Imaging Guides – replace when the imaging guides are heavily 
scratched and defects show in the image. 

This section also provides replacement procedures for the: 

• 

Gear for Self-Centering Side Guides – a spacer is installed in the 
output tray, which allows the side guides to move independently. If you 
want the side guides to move together (self-centering) you can install 
the geared spacer that is included with the scanner. 

• 

Side Guides – short side guides are standard with the scanner.  A set 
of tall side guides is included with your scanner and can be changed 
as required by your application.