Honeywell 1450g User Manual

Page of 206
1 - 6
Mounting a CCB01-010BT Charge Base
Reading Techniques
The scanner has a view finder that projects a bright red aiming beam that corresponds to the scanner’s horizontal field of view.  
The aiming beam should be centered over the bar code, but it can be positioned in any direction for a good read.
The aiming beam or pattern is smaller when the scanner is closer to the code and larger when it is farther from the code.  Sym-
bologies with smaller bars or elements (mil size) should be read closer to the unit.  Symbologies with larger bars or elements 
(mil size) should be read farther from the unit.   To read single or multiple symbols (on a page or on an object), hold the scanner 
at an appropriate distance from the target, press the trigger, and center the aiming beam or pattern on the symbol.  If the code 
being scanned is highly reflective (e.g., laminated), it may be necessary to tilt the code up 15° to 18° to prevent unwanted reflec-
tion.
Menu Bar Code Security Settings
Honeywell scanners are programmed by scanning menu bar codes or by sending serial commands to the scanner.  If you want 
to restrict the ability to scan menu codes, you can use the Menu Bar Code Security settings.  Please contact the nearest techni-
cal support office (see 
 on page 13-1) for further information.
8x32 thread 
x .39 in. (10mm) deep
2.36 in.
59.84mm
3.35 in.
85.09mm
2.8 in.
72.1mm
Linear bar code 
2D Matrix symbol