Honeywell 1450g User Manual

By default, the paging button on the base or Access Point pages the scanners associated with that base or Access Point.  If 
you want the paging button on your base or Access Point to be disabled, scan the Paging Mode Off bar code, below.  
When Paging Mode is off, the base or Access Point will no longer page scanners when the button is pressed.  The red LED 
on the base or blue LED on the Access Point will remain lit to indicate that Paging Mode is off.  (This light will go out when 

the button is pressed, then back on when it’s released.)  Default = Paging Mode On.

When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will 
begin beeping (see 

 on page 3-3).  You can set the pitch of the paging beep for each scanner by scanning one 

of the following bar codes.  Default = Low.