Honeywell 1450g User Manual

If you want the illumination lights on while reading a bar code, scan the Lights On bar code, below.  However, if you want to turn 
just the lights off, scan the Lights Off bar code.  Default = Lights On.

The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken.  Use these codes to set the 
time between when the trigger is pulled and when the picture is taken.  During the delay time, the aiming light will appear, but 

the LEDs won’t turn on until the delay time is over.   Default = Off.

If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning 
digits (0 - 4,000 ms) from the 

 inside the back cover of this manual, then scan Save.

This feature allows you to turn the aimer on and off.  When the Interlaced bar code is scanned, the aimer is interlaced with the 

illumination LEDs.  Default = Interlaced.