Honeywell 1450g User Manual

Page of 206
6 - 1
6
Data Formatting
Data Format Editor Introduction
You may use the Data Format Editor to change the scanner’s output.  For example, you can use the Data Format Editor to insert 
characters at certain points in bar code data as it is scanned.  The selections in the following pages are used only if you wish to 
alter the output.  Default Data Format setting = None.
Normally, when you scan a bar code, it gets outputted automatically; however when you create a format, you must use a “send” 
command (see 
 on page 6-3) within the format program to output data.
Multiple formats may be programmed into the scanner.  They are stacked in the order in which they are entered.  However, the 
following list presents the order in which formats are applied:
1. Specific Terminal ID, Actual Code ID, Actual Length
2. Specific Terminal ID, Actual Code ID, Universal Length
3. Specific Terminal ID, Universal Code ID, Actual Length
4. Specific Terminal ID, Universal Code ID, Universal Length
5. Universal Terminal ID, Actual Code ID, Actual Length
6. Universal Terminal ID, Actual Code ID, Universal Length
7. Universal Terminal ID, Universal Code ID, Actual Length
8. Universal Terminal ID, Universal Code ID, Universal Length
The maximum size of a data format configuration is 2000 bytes, which includes header information.
If you have changed data format settings, and wish to clear all formats and return to the factory defaults, scan the Default Data 
Format
 code below.
Add a Data Format
Step 1. Scan the Enter Data Format symbol (
Step 2. Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate formats.  This allows you to save a total of 4 
different data formats.  To program your primary format, scan using the 
 inside the back cover of 
this manual.  If you are programming an alternate format, scan 12, or 3, depending on which alternate format you are 
programming.  (See  "Primary/Alternate Data Formats" on page 6-9 for further information.)
Step 3. Terminal Type
Refer to 
 (page 6-3) and locate the Terminal ID number for your PC.  Scan three numeric bar codes 
on the inside back cover to program the scanner for your terminal ID (you must enter 3 digits).  For example, scan 0 0 
3
 for an AT wedge. 
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
In the 
 beginning on page A-1, find the symbology to which you want to apply the data format.  Locate 
the Hex value for that symbology and scan the 2 digit hex value from the 
 inside the back cover of 
this manual.
Note: If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable for this symbology.  Scan the four digit data length 
* Default Data Format