Intermec SR60 User Manual

This section describes the Codabar options and contains the 
programming bar codes you can use to configure those options.

The Codabar symbology has the following programmable 
features:

• Check  Digit

• Gap  Check

• Label Length Format

• Start/Stop Character

• Start/Stop Match

• Start/Stop Format

• Read  Verification

Check Digit calculates the check digit to verify the label contents 
have been read correctly.  If you enable this feature, your labels 
must include a check digit. You may also choose to transmit or 
not transmit the check digit.

If the check digit is not calculated, the digit will be sent regardless 
of settings for transmit or don’t transmit.  For example, if you 
choose to transmit check digit, but not calculate it, the scanner 
sends the check digit encoded in the label without verifying its 
accuracy.

Disabling Gap Check allows the scanner to combine two label 
halves printed in close proximity to each other that may have 
been printed at different times and perhaps different locations.

Label length format permits the selection between variable length 
or fixed length formats. For best performance it is recommended 
to use the Fixed Length settings when your application requires 
only one or two label lengths.